Paint over the plastic molding with latex-based paint. You must paint latex with latex or the paint will flake off.
Latex plastic, too admitted as liquid latex casting compound, slush latex or mask latex, is a compound used for manufacture masks, especial object, toys, dolls and a host of other projects. Fabricate your own homemade plastic moulding from latex plastic and a homemade not difficult mould for a fraction of the bill of buying jillion sections of traditional moulding.
Instructions
1. Choose a moulding style that is approximately 1 to 2 inches wider than you desire to install on your walls. The mould and the plastic latex Testament shrink during the drying action. Degree the length of the group of moulding you obtain selected. Degree the span of the moulding. Add 2 inches to the length measurement.
2. Construct a four-sided box with no lid with a backside measuring 4 inches longer than the parcel of moulding by twice the moulding's diameter by 4 inches buried. Decrease pieces of cardboard and tape the pieces tightly calm with duct tape. The box doesn't accept to see pleasant or be fancy.
3. Fill the box 3/4 adequate with oil-based modeling clay. Irrigate your hands with douse and smooth the clay so that the surface is Apartment lodgings and all the more.
4. Centre the quota of moulding over the box of clay. Occupation the molding so the "outside" or the side you would see if the molding were installed on a wall is facing down over the clay. Press the molding into the clay until the back has sunk level with the clay's surface. Gently pull the molding from the clay by wiggling your finger slightly beneath one end of the molding and lift it up. This is the mold. Smooth the end where your finger was inserted, if necessary.
5. Sprinkle the mold lightly with talcum or baby powder.
6. Pour the liquid latex casting compound into the mold until slightly overfull. The latex plastic will shrink as it dries and you can trim excess away with scissors once it is dry. Latex casting compound solidifies at room temperature and doesn't require heat. In mask making you would aim for a hollow product, but for molding allow the latex to remain in the mold.
7. Allow the latex to dry for about four or five days. When the back of the molding springs back when you gently push on it with your finger remove it from the mold by slowly lifting one end and pulling the molding upward.
8. Place the plastic molding on its back. Allow the molding to continue air drying until completely dry to the touch.
9. Install the molding with as few finish nails as will hold it sufficiently.Make plastic moulding from liquid latex casting compound.Moulding for interior decorating can be fictional of resin, plaster, wood or plastic. Moulding lends a finished and crackerjack touch to walls, doors and window frames.
