A Hoover-brand upright vacuum cleaner has an on/off switch in the use that activates the Engine. You can modify a malicious switch yourself, with a infrequent household tools. No electrical skills are required to alter the switch.
Instructions
1. Unplug the vacuum cleaner's faculty cord from the wall Issue, whether it is plugged in. Rotate the Hoover so that the back is facing you. Remove the two screws at the top left and good sides where the grasp tapers in -- cause a Phillips screwdriver to conclude this.
2. Slide the manipulate down as you pull it toward you and off the back of the Hoover. Assign the employ aside.
3. Rotate the Hoover 180 degrees.7. Catch the edge of one of the wires with the needle-nose pliers. Push the site of the wire through one of the contacts on the back of the switch.
4. Unbend the two contacts on the back of the switch with the needle-nose pliers. Accept the mark of one of the wires attached to the back of the switch with the pliers. Pull the wire off the switch using the pliers. Repeat this procedure with the objective of the other wire attached to the back of the switch.
5. Rotate the Hoover so that the back is again facing you. Contain the gratuity of a flat-edged screwdriver below the switch. Lift up on the gratuity to loosen the switch from the compartment it is in. Pull the switch off and dispose of it properly.
6. Dwelling the replacement switch in the position that the beginning switch was occupying. Turn the switch to "Off" provided it is not already fix so. Rotate the Hoover 180 degrees. Direct the bag compartment lid at the top of the Hoover and establish it aside. Remove the three screws -- top and left and good sides -- that are promptly revealed using the Phillips screwdriver. Pull the plastic casing outside from the top of the Hoover and community it aside.
Bend the contact over with the pliers. Repeat this with the other wire.
8. Put the plastic casing back over the switch. Reattach the screws. Close the bag compartment lid.
