Rubber stamps hold many uses. They can be used to decorate paper, walls or furniture. Some rubber stamps hog further been used to decorate fabrics. Rubber stamping is an primary object for crafters, if to Stop a scrapbook project, or to compose a greeting card or stationery. Rubber stamping is a excellent alternative to avail when decorating walls instead of using stencils. You can assemble your own sui generis rubber stamps instead of buying from stores with these steps.
Instructions
1. Conceive of a pattern that you would approximative to bring about as rubber stamps. Haul something on paper first off so you can admit a preferable belief of the diagram rather than putting it on rubber hold up gone. This can save you lifetime, materials and attempt.
2. Glue rubber on a parcel of block.5. Keep the edges of the design smooth by using a nail filer or low grit sand paper rubbed gently against the outline. A nail filer has an advantage of not being too coarse and has a handle to fit inside the crevices.
3. Transfer the imitation. You can convenience carbon paper to transfer your design on rubber. Place the carbon paper in between the rubber and paper, where the side with carbon is placed against the rubber so you can transfer your design. Use a pencil to trace the design that you drew on paper.
4. Carve out your design. You can use a sharp utility knife. For smaller projects use a carving tool with pointed slim edge. When carving the design you are essentially removing the inner rubber within the outline and not the other way around. This way you will leave the design or outline raised. Remove the remnants by blowing in between crevices.
You can obtain rubber stamping supplies at any Art stores. Rubbers can come with pre-cut designs on the other hand you can further obtain naked rubber for you to discover your own diagram. This rubber comes if glued or not on blocks or handles.
6. Start rubber stamping. Test your design on a small piece of paper. Pour ink into a stamp pad then press your rubber stamp firmly on it. Then stamp on a piece of paper by pressing firmly leaving the design on that piece of paper. If you see any gap on the design, return with the carving tool or blade to make that gap appear better.
