The Phantom 2000 abrogating air gadget is a effectual, big efficiency particulate air (HEPA) purification and energy discipline unit designed for flying gift portability. It creates anti vigour to take contaminated air and prevents that air from escaping former the containment barrier. The HEPA filter traps dirt, dust, sawdust, smoke, mould, fumes, drywall dust and other hazardous substances. The Phantom 2000 is built by Recent Containment Systems, Inc. (ACSI) in Houston, Texas.
Instructions
1. Settle the unit in the containment globe. Check the pressure gauge at the control panel. If pressure still exceeds the pressure stated above, the unit requires servicing. Discharge not vent the exhaust into uncontaminated areas.
2. Confirm the unit is turned off before connecting the potential advantage. The leading switch has three positions; alpine, off and low. The Centre position is off. Push the switch to the go to function at low velocity and to the left to function at alpine celerity. Plug in the potency overhaul and turn unit on, initially to low.
3. Bound on giant whether contaminants are at a aerial common. To turn the unit off simply fix the switch to the Centre position. Persist of the project, seal the intake opening with polyethylene movie and duct tape. The built-in Minihelic differential force guage, the indicator aglow panel and alarm Testament let you cognize when filters entail replacing. The Phantom 2000 cleans the air in three stages. The aboriginal leaf is a pre-filter pad which removes exorbitant particles up to 10 microns.
4. Alter the inaugural filter pad provided the air flow faculty of the unit decreases or the compel gauge in the ascendancy panel exceeds 2.6 inches at high-speed or 1.9 inches at low-speed. Turn the unit off and disconnect the power supply. Open the door and remove the contaminated pad for disposal. Replace with a new pad. Close the door and fasten the draw latch. Reconnect power and turn unit on. Check the pressure gauge. If the pressure still exceeds 2.6 inches at high-speed or 1.9 inches at low-speed, the ring panel filter also needs to be replaced.
5. Replace the second stage filter. The second stage filter is a ring panel filter that removes particles up to 1 micron and larger. To change this filter turn the unit off and disconnect the power supply. Open the door and remove the contaminated ring panel filter for disposal. Install a new ring panel filter by placing it against the HEPA filter to position it correctly. Close the door and fasten the draw latch. Reconnect the power and turn the unit on. Check the pressure gauge.
6. Change the HEPA filter if the pressure still exceeds 2.6 inches at high-speed or 1.9 inches at low-speed of water column after changing the other two filters, or after 700 hours of operation. The HEPA filter is the third filtration stage and removes small contaminant particles to 0.3 microns. Turn the unit off and disconnect the power supply. Open the door and remove the ring panel filter. Loosen the four nuts and rotate the tabs to the open position to remove the HEPA filter for disposal. Insert the new HEPA filter in the unit with the gasket end facing the fan. Check to see that it lies squarely on the base bracket. Push the HEPA filter against the HEPA flange bulkhead and rotate the tabs to the closed position. Tighten the hold-down nuts securely to prevent air leaks. Reposition ring panel filter. Close the door and fasten the latch. Reconnect the power supply cord and turn the unit on. The Phantom 2000 requires a minimum of 115 VAC, 60Hz, 20 amp aptitude work and needs to be grounded properly by the ground pin on the plug. Levy the unit outside from doorways and other locations that exposure air turbulence. Lay the deadline of the exhaust Harbour wrapped up an opening in the plastic barrier or wall covering. Seal off any openings using duct tape.
