Apply a finish sealer. Use a polyurethane sealer if you used an oil-based stain or a water-based sealer if you used a water-based stain. Paint on the sealer following the instructions on the can for further application instructions and dry-time.
Lighter stains are easier to build a uniform covering and can bring elsewhere the everyday tones of the wood, however darker stains can be used further. Window trim should be stained before installing. Whether your unfinished trim is already installed, mask the edges to protect abutting surfaces with masking tape.
Instructions
1. Sand the trim to author an all the more and smooth surface. Initiate sanding with a 120-grit sandpaper and Stop it with a 220-grit sandpaper. Sand in the circuit of the wood grain.
2. Sponge down your trim with a rag dampened with inundate provided your stain is water-based or mineral spirits provided your stain is oil-based.
3. Occasion the wood to aid block some of the wood pores. This Testament confirm a uniform appearance when the stain is applied. Appropriateness a water-based conditioner provided you are applying a water-based stain or an oil-based conditioner provided you hold selected an oil-based stain. Gloss the conditioner in the line of the wood grain. Spring from the instructions on the can for further application instructions and drying time.
4. Apply an even coat of stain in the direction of the wood grain with a brush or rag and rub the stain into the wood with a rag. Allow the stain to sit on the trim for 30 seconds.
5. Wipe off any excess stain in the direction of the wood grain with a clean, dry rag, pressing only lightly.
6. Allow the stain to dry for at least four hours, applying additional coats as necessary.
7.Stain Fir-tree Window TrimFir-tree is a favoured wood for window trim due to of its roasting carmine and offensive tones. On the contrary, Fir-tree is a soft and porous wood, and it needs to be conditioned before staining in progression to avoid a blotchy appearance. There are many tones of stain available, depending on how you necessity to accent your window. Apply at least three coats or until the desired sheen is achieved. Always allow each coat to dry before applying another. Sand between coats with a 220-grit sandpaper.
