The installation of a modern hose cistern into a concession stand or trailer requires planning. Deciding on the vastness of the container and its placement too as consequent the regulations as designated by your homeland are foremost. Having a new hose cistern Testament add to the serviceability of your concession stand.
Instructions
Attach with a hose clamp to the drain fitting on the tank, feed the hose through the hole and secure the drain fitting for the floor on the end.8. Secure the hoses between the pump and the water tank with hose clamps.
Fix a spot for the gravity/fill door on a non-service side of the stand. It should be rapid to the drench cistern and slightly above its residence. Intersect an opening to fit the gravity/fill door and install it using the hardware included with it.
3. Operate Teflon tape to the hose barb manlike Trimmings before attaching to the female fittings located on the fresh water tank.
4. Install the water pump near the water tank using the pump installation directions. Remember that the pump should be located between or near the hot water tank and cold water valves.
5. Measure the distance between the gravity/fill door and the tank for the fill fitting and the the vent fitting on the tank. Cut the large hose to arrive the water fill and small hose to arrive the vent.
6. Secure the large and small hoses to the fittings inside the gravity/fill door. Secure the other ends to the tank, with the large hose for the water fill fitting and the small hose for the vent fitting. Secure with hose clamps.
7. Drill a hole for the drain fitting in the floor near the water tank. Measure and cut the hose to run from the drain fitting on the water tank through the hole in the floor.1. Obtain the aqua container placement inside your concession stand. It should be near a sink on the contrary away of the system of traffic and in a aim sturdy Sufficiently to column the weight of the container when filled.2.
Secure the hoses between the water faucets, water heater and pump in the same manner.
