Friday, February 7, 2014

Change A Computer Router'S Mtu

The Maximum Transmission Unit (MTU) is a network principles that defines the vastness of memo packets that cruising along a network system. Counsel packets are bits of hookup that are sent from the source personal computer to the destination. The MTU decides the immensity of these packets, and the dimensions must be consistent across all machines on the network. The MTU proportions of a network is buckle down by the protocol, and most native and occupation networks are ethernet based. You can alternate the MTU setting when some computers on a network are experiencing problems nevertheless remainder of the network isn't affected. Normally, you can convert a machine router's MTU setting by accessing it nailed down your lattice browser.


Instructions


Linksys Router


1. Clear your lattice browser and type in the router's IP direction. This value should be between 1400 and 1492. A good value to begin with is 1454. Change the value as necessary until the network issues are resolved.


2. Click the "Modern" tab at the top of the window. Within this Shade, click the "Filters" link. Within this Shade, scroll down to the MTU possibility and probation the box labelled "Enable."


3. Enter a new MTU size in the text box. The default rate for a Linksys router setup is 192.168.1.1. Enter your router's admin username and password. The default username for Linksys is blank and the password is "admin." Click the "Save Settings" button when you are finished.


D-Link


4. Open a browser window and navigate to the IP address of the router. The default IP address for a D-link router installation is 192.168.0.1.


5. Enter "admin" into the username text box. Enter a password if you previously set a password for the router's admin account. Otherwise, the default password is blank. Press the "Enter" key.


6. Click the "WAN" button on the router's default console screen. On this screen, scroll down to the MTU section. Enter a new value in the MTU text box and click the "Save" button.